Cp-810G, U5996, Photo Printing Solutions And Supplies | Armadillo Photo Supply



8 X10 HD Aluminum Photo Panel - Gloss CLEAR (10 pak)

Item# CP-810GC

ChromaLuxe® Clear Gloss Aluminum Photo Panel, with Rounded Corners. 8" x 10" x .045". These aluminum panels are perfect for portraits, landscapes, or artwork to be used in art galleries or at home. They can also be used for signs for any type of businesses. ChromaLuxe HD Aluminum Photo Panels are extremely durable, offering scratch and abrasion resistance without hiding your image behind glass, also offering the highest fade resistance compared to every other photo medium. For a nice display there are different easels, frames and wall mount options, sold separately.

 

MFG# U5996

CHROMALUXE PANEL SUBLIMATION

Supplies needed:
- sublimatable substrate (ChromaLuxe panel)
- sublimation transfer
- teflon or scratch paper
- heat tape
- soft paper towel

Heat press settings:
- temperature - 400 degrees F
- dwell time - 1 minute 10 secs
- pressure - light

Note: The recommended settings above may need adjustments for best results.
Settings will vary depending on the heat press brand and model ink and paper
and atmospheric conditions.

2nd Note: The layers of soft paper towel achieve two goals: 1. it helps to
distribute the pressure evenly throughout the substrate; 2. it helps to trap
ink that is dispersed outside of the edges of the substrate if there is an
overprint area or full bleed in the artwork.

Layer the press from the bottom pad to the top heat platen as follows:
1. teflon sheet or scratch paper
2. 2-3 layers of soft paper towel (this helps distribute the pressure
evenly)
3. transfer
4. substrate
5. teflon sheet or scratch paper

Steps:
1. Remove the protective plastic coating from the substrate
2. Place the substrate onto the transfer.
3. Tape two ends of the substrate to the transfer using the heat tape on two
sides.
4. Place the transfer and substrate in the press onto the paper towel
(transfer under substrate)
5. Place the teflon sheet or scratch paper over the transfer and substrate.
6. Press the items using the settings listed above.
7. Remove items from the press immediately. Use heat resistant gloves if
necessary - the items will be very hot.
8. Tear the transfer in half opposite of the taped ends.